MANUFACTURING / SINTERING STAGE
Sintering in the NdFeB Magnet Manufacturing Process
A process page explaining how material preparation, forming and sintering connect the drawing to the next production stages.
Drawing-led review preferred. A clear written requirement can start the discussion when a drawing is not ready.
ENGINEERING SNAPSHOTKeep the requirement visible from review to release.
Material and geometry prepared
Part shape enters the route
Confirmed furnace process
Downstream route follows the part
01 / PROCESS POSITION
Where sintering sits in the route.
Powder preparation and pressing establish the formed material. Sintering is the core furnace stage before the downstream route is selected against the part requirement.
Before
Powder preparation and pressing prepare the material and geometry.
Core stage
The formed material moves through the confirmed furnace process.
After
Machining, coating, magnetization and inspection complete the route.
02 / DRAWING INPUTS
The furnace stage still needs a part basis.
Sintering is not a substitute for a part specification. Geometry, grade, dimensions, coating, magnetization and inspection requirements determine how the complete route is reviewed.
Geometry
Shape and dimensions set the part context.
Material
Grade and operating conditions remain project-specific.
Finish
Coating and downstream dimensional needs follow the part.
Release
Inspection expectations are agreed before production.
03 / EVIDENCE AND RELEASE
Process evidence belongs beside the requirement.
Real process evidence is connected to the manufacturing route. Final product performance remains subject to the approved drawing, specification, sample approval and production-lot inspection.
Process record
Keep the route connected to the latest approved requirement.
Sample approval
Use the agreed sample basis before production release.
Lot inspection
Confirm the finished part against the project release plan.
04 / NEXT STAGE
Connect the furnace stage to your part.
Send the drawing or process-critical requirement for engineering and manufacturing review. The next stages can then be discussed in the right sequence.
SINTERING / PROCESS BASIS
Review the route against the part.
A drawing and the process-critical requirement give the manufacturing review a clear starting point.
Discuss the Process